GT PRINT MODEL Super-Fast 3D Printer Resin
GT PRINT ™ MODEL is a patent-pending, super-fast 3D-printer resin formulated specifically for fast, accurate printing of orthodontic models for clear aligners and retainers. It is available in water-washable and air-washable formulations.
Easy to Wash – No IPA!
With GT PRINT MODEL, there’s no need for alcohol (IPA) or other dangerous and expensive cleaning solvents. GT PRINT MODEL is available in two, easy-to-wash formulations:
Option #1: Water-Washable
Can be washed using simple tap water…
Place in Water Bath
Brush with Toothbrush
Let Drip Dry
Option #2: Air-Washable
Can be washed using just air from a standard clinic or laboratory compressor. And with the air-washable formulation, any excess resin you collect when washing is reusable! Just put it back in the printer and print…
Remove from Build Plate
Remove Excess Resin with Air Gun
Ready for a Quick Post-Cure
Fast-Printing and Fast-Curing
GT PRINT MODEL prints up to 60% faster than standard model resins and cures (after printing) faster than standard resins as well*. Whereas standard model resins print at a rate of around 2.2-2.5 seconds per layer, GT PRINT MODEL resins print at a rate of just 0.8-0.9 seconds per layer.
* Data on file. Results may vary by specific brand or individual printer. In our testing in general, GT PRINT MODEL prints and cures significantly faster than standard model resins.
Detailed and Accurate Printing
GT PRINT MODEL allows for printing in high detail and with high dimensional accuracy, well within the tolerances typically required for aligner and retainer models.
Detailed Printing
Accurate Printing
High Strength for More Accurate Thermoforming
After proper printing and curing, models printed with GT PRINT MODEL are super-strong. This strength helps the models maintain their printed dimensions during thermoforming, which helps you make better-fitting aligners and retainers!
| Material Property | Testing Standard | GT PRINT ™ MODEL Results |
|---|---|---|
| Tensile Strength at Yield | ASTM D 638 | 58 MPa |
| Elongation at Break | ASTM D 638 | 11% |
| Flexural Modulus | ASTM D 790 | 2.5 GPa |
| Flexural Strength | ASTM D 790 | 94 MPa |
| IZOD Impact Strength (Notched) | ASTM D 256 | 54 j/m |
| Hardness (Shore D) | ASTM D 785 | 83 |
| * Data from fully-cured models tested by an independent laboratory to the listed standards | ||
Easy to Pour and Easy to Clean
Standard model resins tend to be more syrupy and sticky, but GT PRINT MODEL flows more like water. Its super-low viscosity makes GT PRINT MODEL easier to pour and easier to clean from your printer when done.
Engineered for Easier Recycling
GT PRINT MODEL is engineered to start self-degrading within about one week after use, depending on environmental conditions:
Self-Degrading
Recyclable Powder
Even if you are not participating in recycling programs, this feature should help reduce the amount of space taken up by your discarded models.
If you do have recycling programs available in your area (such as using the discarded material as a filler in various laboratory materials or building substances), this feature should help make the discarded models easier to incorporate into those programs.
Try GT PRINT MODEL Today!
We have special pricing to make it easy to get started with GT PRINT MODEL. Just choose the version that’s best for you:
GT PRINT MODEL Water-Washable
GT PRINT MODEL Air-Washable
Next Up: GT PRINT ™ MODEL Printing Instructions